- Details
-
Category: Repair Articles
-
Published on Thursday, 20 August 2009 20:26
-
Written by Justin Jimmo
-
Hits: 5847
Removing a run with polyester putty
It happens to the best of us, but it happens to the worst of us a little bit more. A dreadful run or sag can cause a great deal of frustration, especially for a perfectionist. I am going to show you how you can eliminate the toughest run and help keep the surrounding area in tact to.
The Run
if you\'ve ever removed one like this you\'ll know they are quite difficulty to completely eliminate. The picture doesn\'t really show it that well, you\'ll get a better idea once the putty is applied, Here it is:
Applying Putty
The theory is that blocking down the putty brings everything down level. Your block wont teeter and you can\'t really angle it either which reduces the chance of breaking through around the run. Just mix up your favorite polyester putty and apply it like so:
As a precaution you can add a bit of tape around it to help prevent scratches outside the putty:
Sanding
You are going to want to start with a coarser paper and gradually upgrit until you finish in about a 1500 or finer. Here we used 400 to start on a hard block (must use a block!). You can start to see how the run is gradually being removed with the putty:
Once the putty is almost removed you should be sanding in about a 1000 grit paper. Here is how we progress:
Once you have removed all of the putty you should switch to a 1500 grit and give it a good blocking, you should have something looking like this once completed:
Next all you need to do is grab your favorite polishing system and shine it back up like any other polishing job. If everything went well you should have absolutely no ghosting of the run and it should be gone. Here is how we finished:
Need a Polyester Putty? Refinish Network recommends using these great products by Eastwood:
|
Comments:
Facebook