need help and advice

Home Forums Main Forum Paint and Refinish need help and advice

This topic contains 2 replies, has 2 voices, and was last updated by Profile photo of zach zach 1 year, 11 months ago.

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • #48696
    Profile photo of jose
    jose
    Participant

    I have a bumper i want to add drl lights to. The bumper doesn’t conform perfectly to the lights. how should i go about contouring it to make it sit flush? i know i can’t use putty cause i would need to build it too high and on such a flexible bumper it would def crack. how should i go about it? the bumper is ppu material. look forward to your advice. thanks

    #48698
    Profile photo of jose
    jose
    Participant

    here’s another pic the way i have it positioned is the pic is how i have it in the other 2 just to show how close it will be after i make the necessary cuts to get it as close as possible.

    Attachments:
    #48806
    Profile photo of zach
    zach
    Participant

    May have to make a couple relief cuts and heat it up and shape as needed. Then use a nitrogen plastic welder to see back up. And/ or use your favorite structural plastic adhesive to smooth things out. If you don’t use a welder don’t forget the reinforcing tape on the back side

Viewing 3 posts - 1 through 3 (of 3 total)

You must be logged in to reply to this topic.