1
{blip}2179017{/blip}
The Refinish Process
Starting with clean, sandblasted metal we will start with a coat of epoxy. This will protect the metal. I used RM\'s EP569 here.
Next I let this flash for 20 min and mix up some 2k Urethane primer surfacer. I am using BASF\'s Glasurit 285-10 / 285-20. It is a black and white primer you can mix together to get the shade you want.
Then it get applied, 2 coats on this:
After it dry\'s it gets block sanded with some 320 and then finished in 600 grit paper. My blend area\'s are done using a grey scothpad in conjuction with some RM 851. It gets dried off, taped up and after it\'s done it will look like this:
To get rid of the sand scratches I\'ll apply an orientation coat (BC100) over that area and it will look like this:
It gives it a bit of a sheen and fills in the minor scratches to make blending easier. Next comes a coat of base, here is what it looks like after the first, then after the third (last).
Ok so now it\'s ready for clear , I\'ll mix up some glasurit 923-109:
Then I\'ll apply 2 coats after tacking it. and here the shine comes:
And heres a few pictures of the final result:
Comments:
fuk I'm a prick 
Facebook
2 days ago
8 days ago
8 days ago
